Watlow 97 series - Input 2 Menu; Output 1 Menu

Active if Output 2 hardware is
present (not 97 _ _-_ A _ _-_ _ _
_) and Setup Page Lock
(Lockout Menu) is not set to
[hide].
717 r/w
[`OFF][`OFF] off (0)
[``AL] alarm (1)
[Ot`2] Output 2
Selects output 2
function.
[Out2] Output 2 Menu
[`set] Setup Page
Active: Always.507 r/w31 to 9999
[LhYS] Limit Hysteresis
Sets the switching
hysteresis for output
1.
Active: Always.700 r/w
[both][both] both (0)
[``hi] high (1)
[``Lo] low (2)
[LSid] Limit Active Sides
Selects output 1
active sides.
[Out1] Output 1 Menu
[`set] Setup Page
Active if input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _),
Input 2 (Input 2 Menu) is set to
[E`in] (Event Input), Event
Function (Input 2 Menu) is not
set to [none] and Setup Page
Lock (Lockout Menu) is not set
to [hide].
1061 r
[``Lo][``Lo] low (0)
[``hi] high (1)
[rise] rise (2)
[FALL] fall (3)
[E`cn] Event Condition
Selects the condition
to trigger an event.
Active if input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _)
or Input 2 (Input 2 Menu) is
set to [E`in] (Event Input)
and Setup Page Lock (Lockout
Menu) is not set to [hide].
1060 r/w
[nonE][none] no function (0)
[Lrst] reset limit (1)
[`LOC] lock out key
board (2)
[`ALr] clear and
silence alarms if
possible (3)
[E`Fn] Event Function
Selects the event
function.
Active if input 2 hardware is
present (97 _1 _-_ _ _ _ -_ _ _ _)
and Setup Page Lock (Lockout
Menu) is not set to [hide].
611 r/w0
[`OFF] off: (0)
[E`In] Event Input:
(1)
[In`2] Input 2
Sets the input type
parameter of input
2.
[Inp2] Input 2 Menu
[`set] Setup Page
Watlow Series 97 Parameters ■ 6.9
Setup Page / Input 2 and Output 1 Menus
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.