Watlow 97 series - Display Menu

6.14 ■ Parameters Watlow Series 97
Setup Page / Display Menu
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
Active: Always.1400 r/w
[`Pr1][`Pr1] actual
temperature (0)
[USEr] user message
(1)
[L`hi] high limit set
point (3)
[L`Lo] low limit set
point (2)
[UdSP] Upper Display
Selects the value
that will appear in
the upper display.
Alarm messages will
toggle in the upper
display if out of
alarm range.
[dISP] Display Menu
[`set] Setup Page
Active if Output 4 is equipped for
communications (96 _ _-_ _ _ R-
_ _ _ _ or 96 _ _-_ _ _ U-_ _ _ _)
and Setup Page Lock (Lockout
Menu) is not set to [hide].
none*11 to 247
[Addr] Address
Sets
communications
address.
*Output 4 parameters cannot
be changed with the Modbus
interface.