Watlow 97 series - Setup Page; Input 1 Menu

Active if Setup Page Lock
(Lockout Menu) is not set to
[hide].
601 r/wIf Sensor
Type (Input
1 Menu) is
changed to
thermocoup
le: [```j],
if Sensor
Type is
changed to
RTD:
[`din]
If Sensor Type is set to
thermocouple
[```j] J (0)
[```H] K (1)
[```T] T (2)
[```e] E (3)
[```n] N (4)
[```C] C (5)
[```d] D (6)
[`Pt2] PT2 (7)
[```r] R (8)
[```s] S (9)
[```b] B (10)
if Sensor Type is set to
RTD
[`din] RTD_DIN (11)
[`JIS] RTD_JIS (12)
[In`1] Input 1
Sets the input
linearization
parameter of the
input 1.
Active if Setup Page Lock
(Lockout Menu) is not set to
[hide].
600 r/w
[``tc][``tc] Thermocouple
(0)
[`RTD] RTD (1)
[Sen1] Sensor Type 1
Sets the input
hardware type of
input 1.
[Inp1] Input 1 Menu
[`set] Setup Page
Active if Setup Page Lock
(Lockout Menu) is not set to
[hide].
[InP1][InP1] Input 1
[Inp2] Input 2 (if
present)
[Out1] Output 1
[Out2] Output 2 (if
present)
[Out3] Output 3 (if
present)
[Out4] Output 4 (if
present)
[dISP] Display
[glbl] Global
[`Set] Setup Page
Go to a setup menu.
Setup Page
The setup page contains 8 menus.
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
Watlow Series 97 Parameters ■ 6.7
NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
Setup Page / Input 1 Menu