Watlow 97 series - Input Calibration Menu

NOTE: For more information about how parameter settings affect the controller’s operation, see Chapter Five, Features.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no]
[``no] no (0)
[`yes] yes (7)
[r380] RTD Calibration,
380Ω
Stores 380.00Ω
calibration for input
1 RTD.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (6)
[r`15] RTD Calibration,
15Ω
Stores 15.00Ω
calibration for input
1 RTD.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (5)
[Lead] Lead Resistance
Calibration
Stores calibration
for lead resistance.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (4)
[`gnd] Set Ground
Stores calibration for
ground at gains of 1
and 32.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (3)
[tc32] Thermocouple
Calibration, 32º
Stores 32 degrees F
type J calibration.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (1)
[tc00] Thermocouple
Calibration, 0mV
Stores 0.000mV
calibration for input
1 thermocouple.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1603 w
[``no][``no] no (0)
[`yes] yes (2)
[tc50] Thermocouple
Calibration, 50mV
Stores 50.000mV
calibration for input
1 thermocouple.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1602 w
[``no]
[``no] no (0)
[`yes] yes (800)
[dflt] Default Settings
Restores default
settings.
Active if Calibration Lock
(Lockout Menu) is not set to
[hide]
1601 w
[``no][``no] No (0)
[`yes] Yes (1)
[`rSt] Restore Factory
Calibration
Restores factory
calibration (Stores
factory calibration
with special key
sequence).
[cin1] Input Calibration
Menu
[Fcty] Factory Page
6.20 ■ Parameters Watlow Series 97
Factory Page / Calibration 1 Menu
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write