Watlow 97 series - Page 58

NOTE: For more information about how parameter seetings affect the controller’s operation, see Chapter Five, Features.
Active: Always19 r
[none][none] none (0)
[reLy] relay (1)
[Proc] process (4)
[`485] (6)
[`232] (7)
[OTY4] Output 4
Hardware
Reads the output 4
hardware type.
Active: Always18 r
[none][none] none (0)
[reLy] relay (1)
[OTY3] Output 3
Hardware
Reads the output 3
hardware type.
Active: Always17 r
[none][none] none (0)
[reLy] relay (1)
[`Ssr] solid-state
relay (2)
[``dc] dc (3)
[OTY2] Output 2
Hardware
Reads the output 2
hardware type.
Active: Always16 r
[reLy][reLy] relay (1)[OTY1] Output 1
Hardware
Reads the output 1
hardware type.
Active: Always4 rnone0.00 to 99.99
[`reu] Software Revision
Reads software
revision number.
Active: Always3 rnone0 to 9999
[Soft] Software ID
Number
Reads the software
ID number.
Active: Always2 rnone0 to 9999
[`Sn2] Serial Number 2
Reads the last four
digits of the serial
number.
Active: Always1 rnone0 to 9999
[`Sn1] Serial Number 1
Reads the first four
digits of the serial
number.
6.18 ■ Parameters Watlow Series 97
Factory Page / Diagnostics Menu
Display Parameter Range Default Modbus Conditions for
Address Parameters to Appear
read/write
[Ity2] Input 2 Hardware
Enabled
Enables the input 2
hardware.
none (0)
[Pret] Process Event
(5)
none 9 r Active: Always