ProtoNode FPC-N34 & FPC-N35 User Manual
APPENDIX F: C-MORE STATUS AND FAULT MESSAGES
OMM-0150_B • 5/20/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 120 of 140
Appendix F: C-More Status and Fault Messages
INLET WATER TEMP
SENSOR SHORT
Inlet water temperature sensor is shorted.
INLET WATER TEMP
SENSOR OPEN
Inlet water temperature sensor is open or missing.
Inlet water temperature is getting too high.
Inlet water temperature is getting too low.
INLET GAS PRESS
SENSOR OPEN
Inlet gas pressure switch is open.
Gas plate differential pressure switch is open.
Oxygen sensor reading is out of range.
Oxygen level is too high.
Heater recirculation pump has malfunctioned.
Waiting for proof of ignition.
Flow input not registering when boiler is starting up.
No ignition current measured when igniter is energized.
Waiting for SSOV to prove open.
Ignition transformer is energized with SSOV closed.
TOO MANY CYCLES IN 24
HOURS
The number of cycles in 24 hour period has been exceeded.
TOO MANY OVRTMPS IN
24 HOURS
The number of over temperature events in 24 hour period has
been exceeded.
The inlet air sensor is out of range.
Auto Diagnostic Mode
ACTIVE
Auto Diagnostic Mode
COMPLETED
Auto Diagnostic Mode
ABORTED
Domestic Hot Water is enabled. Message shows when in
combo mode with a fault in the drive signal.
Informational message during slow shutdown mode.