To start logging samples, press the ‘LOG’ button on the virtual menu. When
logging starts, the device creates a new measurement record identied with its
starting date.
To stop logging samples, press the ‘END’ button or wait until the dened
measurement time is reached. A new screen will appear to show you a
summary screen with all the important information. In this summary screen
you can either go back or show a QR code to export easily the information to
an external App for example.
Important: To store position information along with the eld values, the
GPS receiver must be enabled before logging is started.
Note 1: During logging, the parameters of the SMP2 cannot be changed.
Note 2: With the broadband probes, if you select a limit you can go to the ‘UNITS’
and select a % in power density (%S) or eld intensity (%E or %H).
6.1.1.1. High frequency measurements
International standards have specic requirements for high frequency
measurements. When you make a selection on MENU MEASUREMENT
OPTIONS Standard, the following parameters will be adjusted to the pre-
dened values:
• Measurement time
• Logging rate
• Average type
• Average interval
Then you are ready to measure. Just press the ‘Home’ button and press the
‘LOG’ button on the virtual menu:
• The device will wait the time specied in ‘Wait time before start’ ( see 5.4)
before starting the measurement to allow the technician to move away. A
beep will indicate the start of the measurement.
User’s Manual Electromagnetic Field Meter SMP2 P. 35
To Next Page
Loading...
Need help?
General
