Waveshare RS485 TO ETH - Timeout Reset Function

RS485 TO ETH
serial port side and will disconnect to server after sending all the data to server and no data from
serial port side or network side over a fixed time. This fixed time can be 2~255s, default is 3s. User can
set RS485 TO ETH with non-persistent connection function by web server as follow:
2.4.8. TIMEOUT RESET FUNCTION
Timeout reset function(no data reset): If network side no data transmission beyond a fixed time(User
can set this fixed time between 60~65535s, default is 3600s. If user set a time less than 60s, this
function will be disable), 304 will reset. User can set the Timeout Reset function by web server as
follow:
Figure 18 Non-persistent Connection
Figure 19 Timeout Reset Function