Waveshare RS485 TO ETH - Restore Default Settings; Upgrade Firmware Version

25 pages

To Next Page

To Previous Page

RS485 TO ETH

2.1.2. RESTORE DEFAULT SETTINGS

Hardware: User can press Reload over 5 seconds and less than 15 seconds then release to restore

default settings. Software: User can use setup software to restore default settings.

AT command: User can enter AT command mode and use AT+RELD to restore default settings.

2.1.3. UPGRADE FIRMWARE VERSION

User can contact to salespersons for needed firmware version and upgrade by setup software as

follow:

Figure 4 Static IP/DHCP

Figure 5 Upgrade Firmware Version

Other manuals for Waveshare RS485 TO ETH