Name: Waveshare RS485 TO ETH
Brand: Waveshare
Rating: 5 (1 reviews)

To Next Page

To Previous Page

RS485 TO ETH

2. PRODUCT FUNCTIONS

This chapter introduces the functions of RS485 TO ETH as the following diagram shown, you can get

an overall knowledge of it.

Figure 3 Product Functions diagram

2.1. BASIC FUNCTIONS

2.1.1. STATIC IP/DHCP

There are two ways for module to get IP address: Static IP and DHCP.

Static IP: Default setting of module is Static IP and default IP is 192.168.0.7. When user set module in

Static IP mode, user need set IP, subnet mask and gateway and must pay attention to the relation

among IP, subnet mask and gateway.

DHCP: Module in DHCP mode can dynamically get IP, Gateway, and DNS server address from Gateway

Host. When user connect directly to PC, module can’t be set in DHCP mode. Because common

computer does not have the ability to assign IP addresses.

User can change Static IP/DHCP by setup software. Setting diagram as follow:

Serial

port

Other manuals for Waveshare RS485 TO ETH

Questions and Answers:

Need help?

Do you have a question about the Waveshare RS485 TO ETH and is the answer not in the manual?

General