Wavetek 3000 - Page 204

OPTION - 3
Install the M35-1 module in the location
Before use, the module should be tested
by the procedure shown in Operation
Check .
Note : The above informationapplies to
all 3000 Series instruments exceptModels
3002 and 3004 . For these instruments
the M35-1 is replaced by 1435-2, which
permitsoperation from .001 to 520 MHz,
but does not inlcude DC blocking .

All
otherspecifications, operating instruc-
tions, and descriptionsapply .
QTY
OPTION
3
FIELD
INSTALLATION KIT
DESCRIPTION PART #
1 RF CircuitBreaker Module M35-1
1 RF Cable W1A
1 RF Cable WIB
1
6/32 x 5/8
Screw HS101-610
shown in Figure 8/3-2 and secure with
the 6-32 hold-down screw
. Remove the
front-panelRF output
cable,
W1,
and
replacewith WlA and W1
.B which will
route the RF output
signal
thru
the
?435-1 module .