10
Connecting digital audio system
Connect an optical cable to the connector marked “S/PDIF” at the rear panel of your
receiver and its other end to the respective S/PDIF INPUT OPTICAL connector on the digital
audio system.
Connecting your analog receiver
Connect a coaxial cable from output terminal marked “LOOP” to the RF input terminal of your
analog receiver. Now by keeping your receiver in standby, you will be able to tune and view
analog channels from your analog receiver.
M_180_DNA_HD-T63CX_ENG_120322_jte.indd 10 2012-03-22 �� 2:41:24
To Next Page
Loading...