wbox HD2s - Configuration; Channel Installation; Automatic Channel Scanning; Manual Channel Scanning

To Next Page

To Previous Page

Chapter 5 >> Main Menu

Conguration

Channel Installation

Select Channel Installation using the Arrow (▲/▼) buttons on the Conguration menu

and press the OK button.

Automatic Channel Scanning:

2-1 Select Automatic Channel Scanning and press the OK button.

2-2 DVB-C or DVB-T Automatic scan menu will be displayed

2-3 Select Start and press the OK button to start the channel scan.

2-4 The results of the channel search are shown. Select Save and press OK button to save

all found channels.

Manual Channel Scanning:

3-1 Select Manual Channel Scanning and press the OK button.

3-2 DVB-C or DVB-T Manual scan menu will be displayed.

3-3 Adjust variable settings using the Arrow (▲/▼/◄/►) and Numeric (0~9) buttons.

• DVB-C: Bandwidth, Start Frequency, End Frequency, Symbol Rate, and Modulation.

• DVB-T: Bandwidth, Start Frequency, End Frequency, DVB-T/T2.

3-4 Select Start and press the OK button to start the channel scan

3-5 The results of the channel search are shown. Select Save and press OK button to save

all found channels.

[Note] If you want to delete all channels, select Drop and press the OK button. To change the

tuner type, please do Restore Factory Defaults.

M_180_DNA_HD-T63CX_ENG_120322_jte.indd 25 2012-03-22 �� 2:41:28