Kia Picanto
1317554A_EN
5
Preliminary work
WARNING!
- Open the fuel tank cap and vent the fuel tank.
- Close the fuel tank cap again.
- Disconnect the battery "earth" or "ground" connection.
-Depressurise the cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Completely remove the battery.
- Remove the air filter together with the intake hose.
- Remove the coolant reservoir cap at the left.
- Remove the fuse and relay box.
- Detach the wheel well trim on the right and left.
- Remove the bumper.
- Remove the right headlight.
- Remove the left underride protection.
- Open the right-hand tank-fitting service lid.
- Remove the fuel-tank sending unit in accordance with the manufacturer's instructions.
- Remove the glove compartment.
- Remove the A-pillar trim in the front passenger side footwell.
Remove page 29 "Operating Instructions for the End Customer" and insert in the vehicle operating in-
structions.
Heater installation location
1 Heater
Installa-
tion loca-
tion
To Next Page
Loading...
