12
CONNECTING THE LPG CYLINDER
m WARNING: Make sure that the LPG cylinder or regulator valve
is closed.
A) Connect LPG cylinder.
Some regulators push ON to connect, and pull OFF to disconnect, others have a nut
that has a left-hand thread that connects to the cylinder valve. Follow one of the
specific regulator connection instructions illustrated based on your regulator type.
a) Screw regulator fitting onto tank turning clockwise (1). Position the regulator
so that the vent hole (2) faces down.
b) Screw regulator fitting onto tank turning anti-clockwise (3) (4).
c) Turn regulator lever (5) clockwise to the off position. Push regulator down on
tank valve until regulator snaps into position (6).
d) Make sure regulator lever is in the off position. Slide the collar of the regulator
up (7) (9). Push the regulator down onto the tank valve and maintain pressure.
Slide collar closed (8) (10). If regulator does not lock, repeat procedure.
◆
GAS INSTRUCTIONS
REPLACEMENT HOSE, REGULATOR AND VALVE ASSEMBLY
m IMPORTANT NOTICE: We recommend that you replace the
gas hose assembly on your Weber
®
gas grill every 5 years.
Some countries may have requirements that the gas hose
be replaced within less than 5 years, in which case that
country’s requirement would take precedence.
For replacement hose, regulator, and valve assemblies,
contact the Customer Service Representative in your area
using the contact information on our web site.
Log on to www.weber.com.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
