Weber Genesis E-330 User Manual

WWW.WEBER.COM
13
3
4
5
6
7
8
1
2
GAS INSTRUCTIONS
LEAK-CHECK PREPARATION
m WARNING: The gas connections of your gas grill have been
factory-tested. We do, however, recommend that you leak-
check all gas connections before operating your gas grill.
Remove Control Knobs & Control Panel for Leak Testing
You will need: Phillips & flathead screwdrivers.
A) Locate door pin release in door assembly. Using a screwdriver, push down on door
pin release (1) until door detaches from frame assembly. Pull top of door away from
frame assembly (2) and lift door off bottom adjustable hinge pin.
B) Remove control knobs, igniter button, retention nut, and battery (3).
C) Remove screws from wind deflector with a Phillips screwdriver (4).
D) Tilt end of wind deflector down and slide wind deflector away to remove (5).
E) Let igniter module dangle from wires. Do not disconnect (6).
F) Remove screws from underside of control panel with Phillips screwdriver (7).
G) Lift control panel up slightly, tilt up front edge and gently lift up (8).
H) Replace control panel and wind deflector when leak check is completed.
◆
The grill illustrated may have slight
differences than the model purchased.

Weber Genesis E-330 Specifications

General

Device type	Wheels
Heat source	Natural gas
Total power	12300 W
Smoke function	No
Side burner power	3500 W
Dimensions (WxDxH)	2240 x 870 x 1640 mm
Adjustable thermostat	Yes
Side burners quantity	1
Number of cooking zones	4 zone(s)
Product color	Black
Housing material	Stainless steel
Top surface type	Grate
Cooking surface shape	Rectangular
Cooking surface (W x D)	660 x 500 mm
LED indicators	Temperature

Weight and Dimensions

Depth	870 mm
Width	2240 mm
Height	1640 mm
Weight	114000 g