EasyManuals Logo

Weber Genesis E-330 User Manual

Weber Genesis E-330
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
GAS INSTRUCTIONS
CHECK FOR GAS LEAKS
m WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
NOTE: All factory-made connections have been thoroughly checked for gas leaks. The
burners have been flame-tested. As a safety precaution however, you should recheck all
fittings for leaks before using your Weber® gas grill. Shipping and handling may loosen or
damage a gas fitting.
m WARNING: Perform these leak checks even if your grill was
dealer- or shop-assembled.
NOTE: Since some leak-test solutions, including soap and water, may be slightly corrosive, all
connections should be rinsed with water after checking for leaks.
If your grill has a side burner, make sure the side burner is off.
To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel
anti-clockwise.
m WARNING: Do not ignite burners when leak checking.
You will need: a soap-and-water solution, and a rag or brush to apply it.
A) Mix soap and water.
B) Turn on the cylinder valve using one of the appropriate options based on your
cylinder and regulator type.
a) Turn cylinder valve anti-clockwise (1) (2) (3).
b) Turn regulator lever anti-clockwise to the on position (4).
c) Move regulator lever to the on position (5) (6).
C) Check for leaks by wetting the fitting with the soap-and-water solution and
watching for bubbles. If bubbles form, or if a bubble grows, there is a leak. If there
is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck
with the soap-and-water solution. If leak does not stop, contact the Customer
Service Representative in your area using the contact information on our website.
Log onto www.weber.com.
D) When leak checking is complete, turn gas supply off at the source and rinse
connections with water.
m DANGER
Do not use an open flame to check for gas leaks. Be sure there
are no sparks or open flames in the area while you check for
leaks. Sparks or open flames will result in a fire or explosion,
which can cause serious bodily injury or death and damage to
property.
1
2 3
4
5
2 3
6

Other manuals for Weber Genesis E-330

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Weber Genesis E-330 and is the answer not in the manual?

Weber Genesis E-330 Specifications

General IconGeneral
Device typeWheels
Heat sourceNatural gas
Total power12300 W
Smoke functionNo
Side burner power3500 W
Dimensions (WxDxH)2240 x 870 x 1640 mm
Adjustable thermostatYes
Side burners quantity1
Number of cooking zones4 zone(s)
Product colorBlack
Housing materialStainless steel
Top surface typeGrate
Cooking surface shapeRectangular
Cooking surface (W x D)660 x 500 mm
LED indicatorsTemperature
Weight and Dimensions IconWeight and Dimensions
Depth870 mm
Width2240 mm
Height1640 mm
Weight114000 g

Related product manuals