WEEDO M2 - Filament Replacement

32
Operaon Panel Seng
Aer printer starts heang, LCD would display the real temperature of
spray-head and prinng plaorm. At this moment, if it needs to perform other
operaon, it can press the le buon to return start menu, and heang
process will connue at the backstage. If it needs to end the printer warm-up,
it can enter to warm-up menu and choose “Stop Heang” to stop heang.
6.3.3. Debugging of Printer Funcon
Printer Temperature
In the start menu, choose the third item “Printer Funcon Debugging”, enter
to the secondary menu, choose the first item “Monitoring Mode”, and enter
the real monitoring interface of printer temperature. Press the le buon to
return the last layer of menu.
Filament Replacement
In the start menu, choose the third item “Printer Funcon Debugging”, enter
to the secondary menu, choose the second item “Filament Replacement”,
and enter the manual filament replacement interface.
Utilities
>
Monitor Mode
Filament Loading
Jog Mode
Level Build Plate
Extruder :020C
WEEDO M2
Extruder :020C
Heating>>>
Extruder :020C