WEEDO M2 - Filament Loading

33
Operaon Panel Seng
Choose “Nozzle Filament Return”, press buon OK to enter to filament return
program. Nozzle is heated to preset temperature, and then start nozzle motor
to return filament back. If it needs to end filament return program, press
down the le buon and choose “Yes”.
Choose “Nozzle Filament Entry”, press buon OK to enter to filament entry
program. Nozzle is heated to preset temperature, and then start nozzle motor
to enter the filament forward. If it needs to end filament entry program, press
down the le buon and choose “Yes”
Printer Jog Debugging
In the start menu, choose the third item “Printer Funcon Debugging”, enter
to the secondary menu, choose the third item “Jog Mode”, and enter printer
jog debugging interface.
Utilities
Monitor Mode
Filament Loading
>
Jog Mode
Level Build Plate
Extruder :020C
Utilities
Monitor Mode
>
Filament Loading
Jog Mode
Level Build Plate
Extruder :020C
Unload
>
Load
Extruder :020C
Jog mode
X+
Back Y->
X-
Begin loading or unloading
Press’OK’to exit.
Heating>>>