WEEDO M2 - Page 37

34
Operaon Panel Seng
The jog debugging interface is divided for three screens, which are
corresponding to sha X, Y and Z, and are switched through le and right
buons. In each sha debugging interface, pressing up and down buons can
control the two-ways operaon of printer sha motor. Press buon OK can
return last layer of menu.
6.3.4. Printer Parameter Informaon
View Accumulave Running Time
In the start menu, choose the forth item “Printer Parameter Informaon”,
enter to the secondary menu, choose the first item “printer informaon”, and
enter printer running me stasc interface. Here, it would display
accumulave prinng me, the last me prinng me consuming, filament
use length and others.
Setting&Info
>
Bot Statistics
Settings
Preheat Settings
Version Infoemation
Extruder :020C
Jog mode
Z-
<-Y Back
Z+
Jog mode
Y+
<-X Back Z->
Y-
Lifetime: 30 h 00m
Last Print: 0 h 00m
Filament: 4185.22m
Fil. Trip: 4185.22m