WEEDO M2 - Page 38

35
Operaon Panel Seng
Temperature Offset Seng
When the real prinng temperature doesn't match with the seng
temperature, it can adjust the prinng temperature through “Temperature
Offset”. In the start menu, choose the forth item “Printer Parameter
Informaon”, enter to the secondary menu, choose the second item “General
Sengs”, and enter the third level of menu, choose “Temperature Offset”,
press buon OK to choose this item, press up and down buons to modify the
temperature offset value. The larger the value is, the lower the real prinng
temperature is; When value decreases, the real prinng temperature rises.
Return to the previous menu, please press buon OK→Le buon.
Common Used Prinng Parameter Sengs
n the start menu, choose the forth item “Printer Parameter Informaon”,
enter to the secondary menu, choose the second item “General Sengs”, and
enter the printer parameter seng interface. For the common used items
such as “Voice”, “LED Color”, “Accelerate” and others, they are set with
default On state; for baseboard heang”, it is set with default Off state. If it
appears such condions as no voice, LED light bar can’t be turn on, prinng
resistance becomes large, spray-head move slowly, nozzle doesn't reach the
pre-set temperature and can’t produce filament and print, and others, it
should check whether the relevant parameter seng is at the normal state.
Settings
Auto Power-off OFF
>
Temperature Offse 20
语言设置 英
Extruder :020C
Settings
Auto Power-off OFF
>
Temperature Offse 30
语言设置 英
Extruder :020C