WEEDO M2 - Page 41

38
Operaon Panel Seng
Modificaon of Prinng Speed
Press the le buon of operaon board, it would pop up opon menu, turn
down, and choose “Speed Reset”, and enter to prinng speed reset interface,
press up and down buons to adjust temperature, the over quick prinng
speed would damage the printer, please use cauon to speed up funcon.
Press le buon to return to the prinng interface.
6.3.6. The Forbidden Use Instrucons
Before delivery, each 3D printer has already been performed with debugging
and opmizaon, some instrucons of 3D printer control panel would cover
the running parameters opmized in the printer storage. Therefore users are
not suggested to run the following instrucons by its own. If equipment can’t
work normally as the following instrucons are run careless, please contact
our aer-sales.
�Dio print
�Hot Suspended
�Heat LEDS
�Accelerate
�Nozzle Maintaining
�Nozzle Offset
>
Change Speed
Change Temperature
Set Cooling Fan ON
Print Statistics
Extruder :020C
Change Speed
x1.00
Up/Dn/L/M to Set