WEG WG20 - General Safety

E-4 | WG20 Geared Motors
2. General safety
The customer is responsible for setting up the drive in accordance with good engineering practices.
The instructions in this Mounting Instruction must be followed to achieve the conrmed characteristics of the drive units and
to ensure approval in case of warranty claims.
Make certain that you never put damaged products into operation!
Read this Mounting Instruction carefully before you begin any setup, installation or maintenance work.
Installation, start-up, maintenance and repair work on the gear unit / gear motor as well as on electrical accessory equip-
ment may only be performed by qualied technical personnel, taking the following items into account:
■ Operating Instructions
■ Information labels/tags on the gear unit / geared motor
■ All other project documents, setup manuals, operating manuals
■ Drive-specic specications and requirements belonging to the drive unit
■ The applicable regional and national regulations on safety and accident prevention
Work is only permitted:
■ on the stationary drive,
■ while disconnected and
■ prevented from being switched on again.
Operation of the drive unit by means of a frequency inverter may only occur if the specications shown on the motor name-
plate have been carried out.
WARNING!