USER manual
ENGLISH
53 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
DISPENSING HOT WATER
• Place the jug under the hot water
nozzle;
• press the water button (Y) and
wait for the dispensing of hot
water to take place;
• to halt the dispensing in ad-
vance, press again the hot water
dispensing button (Y) or press
button
.
Avoid contact with the hot water nozzle, do
not direct your hands or other body parts
towards the hot water nozzle ends.
6.11 Dispensing of cappuccino (optional)
• Put the suction tube in the milk;
• place the jug under the spout of the
cappuccino maker;
• open the steam tap, when the de-
sired amount is reached close the
steam tap;
• pour the latte into the cups with
the coee.
For warm milk without foam, lift the ap of the cappuccino maker
upwards.
For better results, we suggest not to dispense directly into the
coee cup, but into a jug or pot, and to then pour the foamed
milk on the coee.
It is recommended to keep the cappuccino maker constantly
clean according to the instructions of paragraph "8.5 Cleaning
operations" on page 55.
Y
6.12 Cup warmer (optional)
The cup warmer device has the task of warming the
cup prior to their use.
• Place the cups on the top shelf (1) of the coee ma-
chine;
• activate the electrical resistor through switch (2).
2
1
For safety reasons it is advisable not to place cloths or other objects
on the cup heater surface to keep the machine from overheating.
6.13 Suggestions on how to obtain a good
cup of coee
Wash daily the lters and lter carrier as instructed in
Par. 8.5.3 on page 56. Failure perform this operation
will compromise the quality of the coee dispensed.
To obtain high-quality coee, it is important that the
hardness of the water used does not exceed 6-7 °f (French
degrees). If the water hardness exceeds these values, it
is advisable to use a water lter or softener. Avoid using
a water softener if the water hardness is less than 4 °f.
If the taste of chlorine in the water is particularly
strong, a special lter should be installed.
Do not to store large amounts of coee beans. If the
type of coee is changed, contact the Manufacturer's
Qualied Technician for the water temperature and grind
adjustment.
After the machine has not been used for a certain
period of time (2-3 hours) carry out a few dry runs. Be
sure to carry out regular cleaning and maintenance.