USER manual
ENGLISH
59 of 216
NERO
C:0 M:0 Y:0 K:100
ROSSO
C:0 M:100 Y:100 K:0
VERDE
C:100 M:0 Y:100 K:0
8.
DISPLAY SIGNALLING
1.0 BAR 120°C
BOILER FILLING
Cause
Boiler lled with water when using
the machine for the rst time or
when relling to reach the water
level.
Description/Action
Wait for the boiler to be completely
lled.
1.0 BAR 120°C
FILLING TIMEOUT
Cause
Time for lling the boiler with water
longer then expected.
Description/Action
Make sure the water mains tap is
opened.
Switch the machine o and back on
again.
In case of persistent signalling after
a few attempts, switch the machine
o and contact the Manufacturer.
DOSER ALARM
Cause
Fault of the volumetric electronic
control .
Description/Action
Stop the dispensing by pressing the
dose button.
Switch the machine o and contact
the Manufacturer.
REG. SOFTENER
Cause
Request of water softener regenera-
tion.
Description/Action
Carry out the water softener regen-
eration.
To eliminate the message, simultane-
ously press the 4 display buttons for 5
seconds: ENTER, MODE, (+), (-).
Problems highlighted in grey require that the machine be switched
o and the Manufacturer’s Qualied Technician be called.
9.
SPARE PARTS
Machine components and/or parts must be replaced
only by the Manufacturer's Qualied Technicians.
The User must not replace the components and/or parts of the
machine.
10.
DECOMMISSIONING
The machine must be decommissioned by the Manu-
facturer's Qualied Technician, because the equipment
must be disconnected from the electricity and water
mains, and all the internal circuits must be emptied of
the water.
The commissioning of the machine after this period
must be performed only by the Manufacturer's Qualied
Technician.
The User must not perform decommissioning after long time and/
or commissioning of the machine.
11.
DISMANTLING
The dismantling of the machine must be performed
by the Manufacturer's. Qualied Technician.
12.
DISPOSAL
12.1 Information for disposal
Only for the European Union and the European Eco-
nomic Area.
This symbol indicates that the product cannot be
disposed of with household waste, according to the
WEEE Directive (2012/19/EC), the Battery Directive
(2006/66/EC) and/or the national laws implementing
those Directives.
The product should be handed over to a designated
collection point, for example the dealer when purchasing
a new similar product, or an authorized collection site
for recycling waste electrical and electronic equipment
(WEEE), as well as batteries and accumulators. Improper
handling of this type of waste can have negative conse-
quences on the environment and human health, due
to potentially hazardous substances that are generally
associated with this kind of waste.