Weidmüller MultiMark - Setting up the printer; Positioning the material reel on the reel holder; Placing labels in the print head

2903400000/00/09.202218
6 Setting up the printer
CAUTION
Danger of injury!
When setting up the printer, work needs to be
carried out with the cover open.
► Make sure that hair, loose clothing, jewel-
lery and the like do not come into contact
with exposed, rotating parts.
6.1 Positioning the material reel on the reel
holder
4
3
1
2
5
Image 6.1 Position the reel material
► Open the cover.
► To unscrew the margin stop (1), turn the adjusting ring
(2) counter-clockwise until the arrow points to the un-
locked icon.
► Pull the margin stop (1) o󰀨 the reel holder (4).
► Slide the material reel (3) onto the reel holder (4) so that
the side of the material to be printed points upwards.
► Place the margin stop (1) on the reel holder (4) and
slide it in until both margin stops are in contact with the
material reel (3) and clear resistance is noticeable when
sliding.
► Turn the adjusting ring (2) clockwise until the arrow
points to the locked icon.
► Unwind a label strip around 60 cm long.
6.2 Placing labels in the print head
4
1
5
3
2
76
Image 6.2 Place labels in the print head
► Turn the lever (2) counter-clockwise to raise the print
head.
► Use the knurled knob (7) to adjust the margin stop (6) so
that the material ts between the two margin stops.
► Guide the label strip over the internal winder to the print
unit.
► Guide the label strip through the label light barrier (3)
so that it exits the print unit between the print head and
print roller.
► Position the margin stop (6) so that the material is guid-
ed without jamming.