312903400000/00/09.2022
SQ laser applicator
10.4 Normal operation
ATTENTION
The printer can be damaged.
The stamp and locking system can collide with each
other.
► Swivel the printer’s locking system at the deection
roller before you start the labelling operation.
► Make sure that all connections are established before
starting the labelling operation.
► Insert the transfer foil and labels.
► Make sure that the locking system is locked.
► Open the shut-o valve for the compressed air.
Before switching on the printer, make sure that
the stamp is not covered by a label. A covered
stamp leads to the incorrect alignment of the
vacuum sensor.
► Switch on the printer.
If the stamp is not in the home position at the
time the compressed air and printer are turned
on, an error message is shown on the display.
► In the printer menu, tap Next to acknowledge
the error and move the applicator to the home
position.
► In the printer menu, tap Feed.
This triggers a synchronisation run of the label transport.
► Manually remove the dispensed labels from the stamp.
After a few seconds, the printer performs a brief return
transport that positions the start of the new label on the
print line.
Perform the synchronisation even if a print job
has been cancelled with the Cancel button.
A synchronisation run is not necessary if the
print head was not opened between dierent
print jobs, even if the printer was switched o.
► Start the labelling operation via the PLC.
Errors that occur during the labelling operation are shown
in the printer’s display, see chapter 10.5.
To Next Page
Loading...
