Weidmüller MultiMark - SQ laser applicator

2903400000/00/09.202228
10 SQ laser applicator
10.1 Conguration
The applicator operation can be modied via parameter
settings while maintaining the basic process.
The key setting is selecting between the “Stamp” and
“Blow” mode of operation.
In addition, the applicator also have various modes relating
to the print order and the application of the label during a
labelling cycle.
Stamp
Print/Apply x
Apply/Print
Wait position top
x
Apply/Print
Wait position bottom
-
The modes of operation can be further modied by setting
several delay times.
For more extensive information on the printer
conguration and on the function of the control
panel buttons, see the printer’s conguration
instructions.
Methods for changing the conguration
► Open the Settings menu.
► Select Labelling.
► Set up the desired parameters.
► Save the settings.
► Switch to the Ready main menu.