Weidmüller MultiMark - Cleaning; Cleaning the print roller; Cleaning the print head

2903400000/00/09.202222
To achieve a good, even print quality, the device should be
cleaned monthly.
DANGER
Risk to life due to mains voltage.
► Make sure that the power cable is discon-
nected.
ATTENTION
The printer can be damaged!
Strong detergents, abrasive cleaners or solvents can
damage the printer. Only use all-purpose cleaners to
clean the exterior surfaces or assemblies.
► Remove dust and paper lint in the print area with a soft
brush or a vacuum cleaner.
► Clean the exterior surfaces of the printer with all-pur-
pose cleaner.
8.1 Cleaning the print roller
Contamination on the print roller can impair the print image
and prevent material transport.
► Swivel the print head away.
► Remove labels and transfer foil from the printer.
► Remove deposits with roller cleaner and a soft cloth.
► If the roller is damaged, replace it; see Service.
8.2 Cleaning the print head
During printing, contamination may collect on the print
head and negatively a󰀨ect the print image, e.g. due to con-
trast di󰀨erences or vertical strips. Regular cleaning makes
an important contribution to preventing premature wear on
the print head.
Recommended cleaning interval: Clean the print
head each time after changing the transfer foil
reel.
CAUTION
Risk of injury due to hot print head.
Allow the print head to cool before com-
mencing cleaning.
ATTENTION
The print head can be damaged!
Hard or sharp objects can scratch the print head. Do not
touch the protective glass layer on the print head.
► Swivel the print head away.
► Remove labels and transfer foil from the printer.
► Clean the print head with a special cleaning pen or with
a cotton swab dipped in pure alcohol.
► Leave the print head to dry for 2 to 3 minutes.
8 Cleaning