212903400000/00/09.2022
7 Printing
ATTENTION
Incorrect handling can damage the print head!
► Do not touch the underside of the print head with your
ngers or sharp objects.
► Make sure that the labels are not contaminated.
► Ensure the smooth surface of the labels. Rough labels
act like an abrasive and reduce the service life of the
print head.
► Print with the lowest possible print head temperature.
The printer is ready for use when all connections are es-
tablished and the labels as well as, where necessary, a
transfer foil have been inserted.
7.1 Synchronising the paper run
In cutting mode, the paper run must be synchronised after
inserting the label material. To do so, the rst label detect-
ed by the label sensor is moved to the print position and all
labels in front of it are transported out of the printer. This
prevents an incorrect cutting length of the rst cut, which
would make the rst label unusable.
► Tap the feed icon to start the synchronisation.
► Remove the empty labels dispensed and cut during the
feed process.
A synchronisation run is not necessary if the
print head was not opened between dierent
print jobs, even if the printer was switched o.
To Next Page
Loading...
