WeighTech WT3000-P - 12 ERROR MESSAGES

WEIGHTECH USA Weighing indicator WT3000-IR ABS– Technical manual
Wt3000irabs v20151126
39
12 ERROR MESSAGES
E0
The EEPROM It's not working properly, it has not been programmed or
the main board is damaged.
E1
The zero weight value is above the zero range.
E2
The zero weight value is under the zero range.
E4
A/D converter unstable. (Internal value oscillating)
oL
A/D circuit damaged.
Load cell misconnection
Weight overload.
-oL
A/D circuit damaged.
Load cell misconnection
Weight negative overload.
oF
The value of the A/D converter is above the operating range.