WEIHONG NCStudio V12 - Shoot by Single Point; Shoot by Two Points

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
28 / 47
Shoot by Single Point
When programming, you need to set the circle center as the workpiece origin. After
shooting, the system will set the found center as the workpiece origin.
This operation is suitable to process circles.
To shoot by single point, do the following:
1. Switch to Param page and set the parameter CCD Shoot mode to 1.
2. Move to the circle center and click Shoot to record the position of the shooting
point.
After setting, click Template Edit. Outline Positioning dialog box pops up. For
details, please refer to Edit a Template.
Shoot by Two Points
With this shooting method, the positions of the shoot points are the theoretical
position on the drawing.
To shoot by two points, do the following:
1. Set the workpiece origin and the first shooting point:
It is recommended to do the following:
1. Switch to Craft page and check Setting ON and Set Work Zero by CCD
Center.
2. Move X-axis and Y-axis to the position of the first shooting point, and
click Clear → X and Y.
3. Switch to Set page and click Pick Current under Mark 1.
At this time, the position of the first shooting point is the workpiece
origin.
2. Switch to Param page and set the parameter CCD Shoot Mode to 2.
3. Set the second shooting point under Mark 2.
It is recommended to manually input the position of the second shoot point,
according to the distance between the two shooting points.