上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
40 / 47
4. Select compensation type:
– Overall compensation
It is the common compensation type.
With array machining enabled, the set workpiece offset compensation is
suitable for all workpieces in the array.
– Single compensation
With array machining enabled, the workpiece offset compensation of
each workpiece needs to be individually set.
When lead screw of the machine results in the damage of a certain
workpiece, single compensation is required.
5. Set the workpiece size.
6. Set related parameters for overall compensation or single compensation.
After setting, if the workpiece origin is not at the center of the workpiece, further
adjust the offset compensation of X-axis and Y-axis.
4.4.8. Set Z-axis Depth Compensation
With array machining enabled, all workpieces are in the same horizontal plane, so
one of the workpieces damaged takes a long time to machine all the workpieces
from start. At this time, you can set Z-axis depth compensation for the replaced
workpiece after machining.
To Next Page
Loading...
Need help?
General
