24 Operation
Emptying the re-usable collection canister
If the re-usable collection canister is full to the limit,
you must interrupt aspiration and empty the collec-
tion canister.
Important When removing the collection canister, take care
that the secretion cover is not opened accidentally,
allowing the contents to spill over.
1. Unwind the aspiration tube from the tube holder
plate to make it easier to remove the canister
and reduce the risk of the secretion cover com-
ing open by accident.
2. Remove the re-usable collection canister from
the motor unit by pulling the locking tab out and
lifting the canister out of its holder.
3. Carefully remove the secretion cover.
4. Empty the collection canister.
Important Be sure to observe the relevant rules for disposal
(see “3. Safety instructions” on page 11).
5. Replace the secretion cove on the collection
canister.
6. Replace the collection canister in its holder on
the motor unit. Please make sure that the secre-
tion cover is forced down onto the motor unit
and the locking tab slots into place with the
bracing clip.
7. If necessary, reattach the aspiration tube. You
can now continue with aspiration.
To Next Page
Loading...
Need help?
General
