4) Aerwards the NAT rule appears in the Network Address Translation (NAT) Rules table as shown below
The rule is now active. The corresponding services restart and the port mapping is fully set up.
For a working port mapping it is helpful to check the settings of the connected devices in advance. The following
checklist is helpful (according to the example above):
• Does the camera have the IP address 192.168.2.12?
• Does it respond at “ping 192.168.2.12”?
• Is the web interface of the camera accessible via http://192.168.2.12?
• Is the Welotec router entered as the default gateway for the camera (192.168.2.1)?
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 19
To Next Page
Loading...
