4 4. Technical Specifications
4.1 Device Properties
Property
Value
Dimensions (W x H x D) 45 x 132,6 x 112,8 mm
Operating voltage 230 V AC to 12 V – 48V DC
Power consumption Standby 3,8 W
Power consumption Active 5,3 W
Approval CE compliant
4.1.1 UL Compliance Statement
WARNING
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
If the EUT was tested with special shielded cables the operator’s manual for such product shall also contain the
following statements or their equivalent: Shielded interface cables and/or AC power cord, if any, must be used in
order to comply with the emission limits.
In order to meet FCC emissions limits, this equipment must be used only with cables that comply with IEEE 802.3.
4.1.2 ICED ‑ Canadian Compliance Statement
This Class A digital apparatus meets all requirements of the Innovation, Science and Economic Development
Canada ICES‑003.
4.2 Environmental Conditions
Property
Value
Operating temperature range ‑25 to + 70 °C
Storage temperature range ‑40 to +85 °C
Air humidity 5 ‑ 95 %, non condensing
Concussions IEC 60068‑2‑27
Free fall IEC 60068‑2‑32
Vibration IEC 60068‑2‑6
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 146
To Next Page
Loading...