3.12.6.3 Enable password Command
It is always possible to change the password of the super user (adm) via the CLI. You can do this with the enable
password command. The input format for this is
Enable password [password]
3.12.6.3 Username Command
The Username command allows you to create users to access the router. The syntax for the input is
Username [Username]
When creating the user, you will be asked for a new password that you can assign here. The user that is created is
always a standard user.
Welotec GmbH
Zum Hagenbach 7
48366 Laer
www.welotec.com
info@welotec.com
+49 2554 9130 00
Page 145
To Next Page
Loading...
