51
WHILL Model F User Manual
3
3. Assembly and adjustment
3.
Disconnect the cable connector under the seat.
• When disconnecting the connector, hold and rotate
the base lock of the connector. Do not rotate other
parts of the connector.
• When disconnecting the connector, do not pull
forcefully. There is a risk of breaking the cables.
Base lock of the
connector
4.
Loosen the arm rest adjustment screw.
To loosen a re-tightened screw, use a Phillips
screwdriver.
Arm rest adjustment screw
5.
Remove the arm rest.
6.
Remove the arm rest on the opposite side in the same
way.
7.
Remove the controller and hand rest from the arm
rest.
For the removal procedure, refer to Steps 1 to 5 in “3.2.4.
Installing the arm rests” “■Installation pattern 2” (on
page 32).
To Next Page
Loading...
