22
List of other generic questions from customer / end consumer
How works........ ? Answer
Freezer Temperature button: This button needs to set up the Freezer
temperature set-point from -24°C to -18°C
Fridge Temperature button: This button needs to set up the Fridge
temperature set-point from +2°C to +6°C
Ice ON/OFF button: This button needs to engage/disengage the
Ice-Maker and the functions related with it
(Ice-Mode).
Alarm reset button: This button needs to switch OFF the
buzzer when active ( Mute Mode ).
Stand- By button: This button needs to switch ON/OFF the
appliance without remove the power supply.
Ice mode button: This button needs to engage/disengage the
Cubed/Crushed ice mode (it will change the
blades rotation).
Dispenser lamp button: This buttons needs to switch ON/OFF the
dispenser lamp (the dispenser lamp will be
switched ON every time the paddle is
pressed).
De-frost: It is a function that automatically engages the
De-frost HEATER when the bimetal sensor is
closed (ice on evaporator) and 8 hours of
compressor running are elapsed. De-frost stop
automatically when bimetal open.
No-frost: No-frost means that the cooling is made by
means cold air circulation.
Long black-out: Your appliance has got the following
function: an alarm will be activated after a
power restoring if the appliance was in the
The alarm is engaged just in case that
temperature value inside the unit has risen
above -8°C.
Long black-out alarm: The temperature value detected at the
moment of power restoring is displayed
(blinking) until the OK button will be pressed.
To Next Page
Loading...
