Wilo EHV G2 - DN 50/2RK - CE Marking; Electrical Work

28 WILO SE 11/2016 Ed.01 DIN A5
English SAFETY
PROHIBITION symbol, for example, Keep out!
INSTRUCTION symbol, for example, wear protective clothing
The safety symbols used conform to the generally valid directives and regulations,
suchasDINandANSI.
Each safety instruction begins with one of the following signal words:
• Danger
This can result in serious or fatal injuries!
• Warning
Serious injuries can occur!
• Caution
Injuries can occur!
• Caution (instruction without symbol)
Substantial material damage can occur. Irreparable damage is possible!
Safety instructions begin with a signal word and description of the hazard, followed
byitscauseandpotentialconsequences,andendwithadviceonprevention.
Example:
Beware of rotating parts!
The moving impeller can crush and sever limbs. Switch off the device and let the
impeller come to a halt.
2.2. CE marking
If the product is obliged to carry a CE marking,
• the marking is attached to the product and
• a copy of the EC declaration of conformity is enclosed or is part of this operating
manual.
2.3. Electrical work
Ourelectricalproductsareoperatedwithalternatingorthree-phasecurrent.Thegov-
erning national directives, standards and regulations (e.g. VDE 0100) as well as the
requirements of the local public utility company must be observed.
The section entitled "Electrical connection" must be observed when connecting
theproduct.Thetechnicalspecicationsmustbestrictlyadheredto.
ELECTRICAL hazard!
Incorrectly performed electrical work can result in fatal injury! This work may only
