en
34 WILO SE 2019-11
3.5 Safety instructions
Electrical current
DANGER
Electric shock!
The pump is operated electrically. An electric shock
may be a danger to life!
▪Have only qualified electricians carry out work on electrical com-
ponents.
▪Before all work, deactivate the power supply (if necessary, SSM and
SBM) and safeguard against accidental switch-on. Work on the
control module may only be started after 5minutes have elapsed,
due to the dangerous residual contact voltage.
▪Operate pumps exclusively with intact components and connection
cables.
Magnetic field
DANGER
Magnetic field!
The permanent magnet rotor inside the pump can
pose mortal danger for people with medical implants
(e.g. pacemakers) during dismantling.
▪Never open the motor and never remove the rotor.
Hot components
WARNING
Hot components!
Pump housing, motor housing and lower module
housing can get hot and cause burns if touched.
▪When in operation, only touch the user interface.
▪Allow the pump to cool down before commencing any work.
▪Keep highly flammable materials away.
4 Transportation and storage
4.1 Scope of delivery
➜Fig.1 and 2
4.2 Accessories
Accessories have to be ordered separately.
▪CIF modules
▪PT1000 (Contact and immersion sensor)
▪Counter flanges (DN32 to DN100)
▪ClimaForm
See catalogue for detailed list.
4.3 Transport inspection
Check delivery immediately for damage and completeness. Where
necessary make a complaint immediately.
To Next Page
Loading...
Need help?
General
