What to do if Windsor Commodore 20 Floor Machine vacuum motor will not run?
If the vacuum motor on your Windsor Floor Machine won't run, first check if the vacuum circuit breaker has tripped and reset it. If the issue continues, it may be due to a faulty main vacuum switch, loose wiring, or a faulty vacuum motor, all of which require professional service.
Why Windsor Commodore 20 will not propel when handles are squeezed?
If your Windsor Floor Machine does not propel when the handles are squeezed, start by checking if the circuit breaker has tripped and reset it. Also, verify that the speed control knob is not set to zero; turn it clockwise to a higher speed. If neither of these resolves the issue, the problem might be a faulty speed control board or propel motor, requiring professional service.
What to do if the brush does not spin on Windsor Commodore 20?
If the brush on your Windsor Floor Machine isn't spinning, first ensure the brush switch is turned on. Then, check if the brush circuit breaker has tripped and reset it if necessary. Also, make sure the propel lever is squeezed to activate the brush. Check the brush belt and replace it if broken.
What causes Windsor Commodore 20 Floor Machine solution and brush to turn on when brush switch engaged?
The Windsor Floor Machine solution and brush turn on when the brush switch is engaged because of a faulty micro switch, which requires professional service.
Critical guidelines for safe operation to prevent personal injury and equipment damage.
Defines hazard signal words (Warning, Caution, For Safety) and their meanings.
Details proper electrical grounding procedures for safe machine operation.
Illustrates the location of safety warning labels on the machine.
Lists all technical data, dimensions, and capacities of the carpet extractor.
Overview and identification of all control buttons, switches, and levers on the machine.
Detailed explanation of how to operate the machine's forward and backward movement.
Step-by-step instructions for filling the solution tank and chemical compatibility.
Guides the user through starting, adjusting, and operating the machine.
Instructions for proper brush height adjustment for optimal cleaning.
Method for operating the machine to clean carpets, including special considerations.
Instructions on connecting and using auxiliary tools for specialized cleaning tasks.
Routine monthly tasks to prevent system buildup and maintain performance.
Essential daily and regular checks and cleaning procedures for machine upkeep.
A checklist of maintenance tasks categorized by frequency (daily, weekly, quarterly).
Identifies common problems, their causes, and solutions for efficient problem-solving.
General| Electrical | 230V, 8 A, 50 HZ |
|---|---|
| Power Cable | 75’ (23 m) (12 gauge) |
| Electric Propelling Motor | (1) –1/4 hp DC (186 watts) with variable speed forward. |
| Electric Vacuum Motor | (1) – 3 stage, 1 hp 99 cfm (2.80 m³/min.) |
| Drive System | Transaxle unti variable speed Operating Speed: 0-100ft/min (30m/min) |
| Waterlift | 117” (297 cm) |
| Brush Speed | 1000 RPM |
| Solution Capacity | 20 Gallons (75 ltr) |
| Recovery Capacity | 20 Gallons (75 ltr) |
| Brush | (1) 18” (45.8 cm) |
| Solution Pump | 100 psi (6.9 BAR), diaphragm style, demand pump |
| Solution Spray | 2 quick change jets |
| Vacuum Shoe | 22” (56 cm) wide, cast urethane floating and pivoting. |
| Wheels - Front (2) - Rear (2) | 4” dia. (10 cm) caster by 2.5” 10” dia (25 cm) wheels by 2” |
Weight and Dimensions| Dimensions - Weight | 215 lbs. (98 kg) |
|---|---|
| Dimensions - Length | 51” (130 cm) |
| Dimensions - Height | 44” (111 cm) |
| Dimensions - Width | 22” (56 cm) |
To Next Page
