23
AFTER SALES SUPPORT
1300 663 907 CUSTOMERCARE@WINPLUS.COM.AU MODEL: HE170703
ADDITIONAL SETTINGS
7.1 Quick Settings
To access the Quick Settings, press the dial button and select Quick Settings in the Main Menu
Move:
• Move X, Y, Z: Manually move the X, Y, Z axes by 1mm increments
• Extruder: Manually extrude or retract lament by 1mm increments
IMPORTANT NOTE: you must preheat the extruder to extrude or retract lament, 180ºC minimum
• Home XYZ: Return to the home position in the front right corner
Change Filament:
• Add Filament: On screen guide to Add Filament if no lament is currently inserted
• Remove Filament: On screen guide to remove lament if currently inserted
• Preheat: Preheat the nozzle
• Raise Extruder 10mm: Raises the extruder by 10mm
Disable Steppers: Disables all motors so you can manually move the bed and extruder position in
the X and Y directions
Preheat: Preheat the nozzle
Cooldown: Cools the nozzle
7.2 Advanced Settings
To access the advanced settings, press the dial button and select Advanced in the Main Menu.
Unless you are an experienced user we do not recommend adjusting settings in the Advanced
Menus.
Temperature:
• Nozzle: Set the current temperature of the nozzle (0-250⁰C)
• PID-P: Proportional response
• PID-I: Integral response
• PID-D: Derivate response
• Preheat PLA conf: Adjusts the default PLA heating temperature
Save Setting: Saves the current settings
NOTE: You must save settings after every change. Unsaved settings will be lost after restart
Factory Reset: Restores default factory settings
To Next Page
Loading...
Need help?
General