Chapter 2: Getting Started
EN-14
2.2.2 Device Joining via Router (
Power Switching
)
1. Plug in the power switch to the wall outlet.
2. Short press the SET button on the power switch.
Wait until the LED indicator blinks green before releasing the SET
button.
3. Remove the sensor bracket if necessary.
4. Short press the SET button at the back of the
sensor.
Wait until the LED indicator blinks green
before releasing the SET button.
•For CO
2
sensor, press both the and
buttons until the screen blinks.
5. To verify if the device binding process is successful, do one of the
following:
• Wait for few seconds until both indicators (on the router and device)
turned off.
• Click Refresh icon on the web console to verify if the device binding
process is successful.
6. Repeat above steps to bind other devices.
Wireless Contact Sensor
LED
To Next Page
Loading...