EasyManua.ls Logo

Wolf BWL-1 S - Technical Parameters According to EU Regulation No. 813;2013

Wolf BWL-1 S
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
118 3064298_201507
58. Technical parameters according to
EU regulation no. 813/2013
Type BWL-1S(B)-07/230V BWL-1S(B)-10/400V BWL-1S(B)-14/400V BWL-1SB-10/230V BWL-1SB-14/230V
Air-to-water heat pump [yes/no] yes yes yes yes yes yes yes yes yes yes
Water-to-water heat pump [yes/no] no no no no no no no no no no
Brine-to-water heat pump [yes/no] no no no no no no no no no no
Low-temperature heat pump [yes/no] no yes no yes no yes no yes no yes
Equipped with a supplementary
heater
[yes/no] yes/no yes/no yes/no yes/no yes/no yes/no yes/no yes/no yes/no yes/no
Heat pump combination heater [yes/no] no no no no no no no no no no
Values shall be declared for medium-temperature application (55°C)/low-temperature application (35°C)
for average climate conditions
Item Symbol Unit 55°C 35°C 55°C 35°C 55°C 35°C 55°C 35°C 55°C 35°C
Ratedheatoutput(*) P
rated
kW 6 7 11 10 13 12 10 10 11 12
Declared capacity for heating for
part load at indoor temperature
20°C and outdoor temperature
Tj= -7°C Pdh kW 6,0 5,9 8,3 8,5 9,2 11,0 8,0 9,0 7,9 9,8
Tj= +2°C Pdh kW 3,5 3,7 5,2 5,5 7,3 6,7 5,1 5,5 6,8 6,7
Tj= +7°C Pdh kW 2,9 2,8 4,5 5,0 4,7 5,1 4,6 4,8 4,7 4,9
Tj= +12°C Pdh kW 3,1 3,4 5,1 5,9 4,9 5,1 5,6 5,8 5,5 5,2
Tj= bivalent temperature Pdh kW 4,7 5,9 8,0 9,3 8,9 10,8 7,8 7,9 8,3 8,9
Tj= operation limit temperature Pdh kW 5,5 6,6 8,2 9,3 9,4 10,8 6,8 9,1 6,8 8,7
For air-to-water heat pumps Tj =
-15°C (if TOL < -20°C)
Pdh kW - - - - - - - - - -
Bivalent temperature T
biv
°C -3 -7 -3 -8 -3 -8 -5 -5 -3 -4
Seasonal space heating energy
efciency
n
s
% 133 180 130 195 131 178 111 150 111 150
Declaredcoefcientof
performance or primary energy
ratio for part load at indoor
temperature 20°C and outdoor
temperature
Tj= -7°C COPd - 2,11 2,96 2,05 2,97 2,03 2,86 1,64 2,52 1,61 2,23
Tj= +2°C COPd - 3,41 4,33 3,22 5,00 3,25 4,04 2,89 3,63 3,01 3,93
Tj= +7°C COPd - 4,12 5,95 4,30 6,21 4,77 6,68 4,10 5,34 4,29 5,51
Tj= +12°C COPd - 5,31 7,21 5,30 7,36 5,20 8,58 5,23 7,32 4,95 5,27
Tj= bivalent temperature COPd - 2,60 2,96 2,51 3,08 2,51 2,86 1,85 2,84 2,01 2,82
Tj= operation limit temperature COPd - 1,85 2,66 1,86 2,81 1,86 2,86 1,38 2,10 1,38 2,04
For air-to-water heat pumps Tj =
-15°C (if TOL < -20°C)
COPd - - - - - - - - - - -
For air-to-water heat pumps:
Operation limit temperature
TOL °C -10 -10 -10 -10 -10 -10 -10 -10 -10 -10
Heating water operating limit
temperature
WTOL °C 55 55 55 55 55 55 55 55 55 55
Power consumption in modes
other than active mode: Off
mode
P
OFF
kW 0,007 0,007 0,026 0,026 0,026 0,026 0,026 0,026 0,026 0,026
Power consumption in modes
other than active mode:
Thermostat-off mode
P
TO
kW 0,011 0,011 0,026 0,026 0,026 0,026 0,026 0,026 0,026 0,026
Power consumption in modes
other than active mode: Standby
mode
P
SB
kW 0,010 0,010 0,026 0,026 0,026 0,026 0,026 0,026 0,026 0,026
Power consumption in modes
other than active mode:
Crankcase heater mode
P
CK
kW 0,000 0,000 0,000 0,000 0,000 0,000 0,000 0,000 0,000 0,000
Supplementary heater: Rated
heat output
P
sup
kW 0,9 / 0,0 0,1 / 0,0 2,6 / 0,0 0,8 / 0,0 3,5 / 0,0 2,8 / 0,0 2,84 / 0,0 0,7 / 0,0 4,61 / 0,0 2,9 / 0,0
Type of energy input - - electrical electrical electrical electrical electrical
Capacity control xed/variable variable variable variable variable variable
Sound power level, indoors L
WA
dB 42 42 42 42 44 44 42 42 44 44
Sound power level, outdoors L
WA
dB 61 61 60 60 61 61 61 61 61 61
For air-to-water heat pumps:
Ratedairowrate,outdoors
- m3/h 2600 2600 3500 3500 4200 4200 3800 3800 3800 3800
For water-/brine-to-water heat
pumps: Rated brine or water
owrate
- m3/h - - - - - - - - - -
Contact details Wolf GmbH, Industriestraße 1, D-84048 Mainburg
(*)Forheatpumpspaceheatersandheatpumpcombinationheaters,theratedheatoutputP
rated
is equal to the design load for heating P
designh
, and the rated heat output of a supplementary
heater P
sup
is equal to the supplementary capacity for heating sup(Tj).

Table of Contents

Related product manuals