Wolf BWL-1 S - Active Cooling; DHW Quick Heat-Up; Energy Saving Mode (no Function)

553064298_201507
29.4.4 DHW quick heat-up
Setting range: Off, On
Factory setting: Off
If this parameter is set, the DHW temperature is controlled once to the set value using all available heat sources. The parameter
is then automatically reset.
Main menu Submenu Menu item
Main menu
← back
Displays
Default settings
Contractor
← back
Default set.
← back
Key lock
DHW op mode
DHW quick heat-up
← back
DHW quick heat-up
ON
29. Operating the AM display module
29.4.5 Energy saving mode
No function
29.4.6 Active cooling
Setting range: Off, On
Factory setting: Off
Enables the user to activate/deactivate active cooling.
Thisrequiresthatthesystemisconguredwithactivecoolingandthatactivecoolingisenabledviacontractorparameter
WP058 (factory setting: Off).
During active cooling, the cooling capacity of the heat pump is transferred to the heating system.
Cooling
Cong.
1, 5, 14,
15, 51
WP058
ON
Outside temp.
>
WP053
BM-2/AM
Default setting
Act. cooling
On
Cooling active
Cooling deactivated
No
No
No No
Yes Yes
Yes Yes
Main menu Submenu Menu item
Main menu
← back
Displays
Default settings
Contractor
← back
Default set.
← back
DHW quick heat-up
Energy saving mode
Active cooling
← back
Active cooling
On