Wolf COB - Installation Accessories

14
3062547_201507
9. Installation - accessories
We recommend making the connection to the heating system with the following parts from the Wolf accessories range.
COBconnectionsetadjacenttothewallcomprising:
2 cross pieces, each with one connection
2 clips
1 corrugated stainless steel pipe 1", length 1 300 mm
1 corrugated stainless steel pipe 1", length 800 mm
1 silicon grease tube
COBconnectionsetwithTSadjacenttothewallcomprising:
2 cross pieces, each with two connections
4 clips
3 corrugated stainless steel pipe 1", length 1 300 mm
1 corrugated stainless steel pipe 1", length 800 mm
2 corrugated stainless steel pipes ¾", length 800 mm
1 silicon grease tube
1 trimming set ¾"
COBconnectionset adjacent to thewallfor a freestanding
cylinderuptoSEM-1-750andSE-2-750comprising:
2 cross pieces, each with two connections
3 corrugated stainless steel pipe 1", length 1 300 mm
1 corrugated stainless steel pipe 1", length 800 mm
4 clips
1 silicon grease tube 6 at packings 1"
1 pipe bend 2 at packings 1½" EPDM
1 pump 1 adaptor tting G1½" (fem.)
2 double nipples G 1" (male) - G 1" on G1" (male)
1 elbow with air vent
TSaccessorysetforcoldwatercomprising:
1 expansion vessel 8 l
1 cold water connection pipe to the expansion vessel
2 double nipples ¾"
1 trimming set ¾"
Pipeassemblycomprising:
1 circulation pump
2 thermometers in ow and return
2 ball valves in ow and return
- Incl. / excl. mixer
- With manifold for 2 or 3 pipe assemblies
For further accessories, such as a safety assembly 1" or wall mounting bracket for pipe assembly, etc., see
"Heatingsystems"pricelist
TSDHWcirculationpumpaccessorysetcomprising:
1 analogue DHW circulation pump
1 corrugated stainless steel pipe ¾"
1 trimming set ¾"
Neutralisationbox,incl.plinthcomprising:
1 granulate ll
1 installation accessories set
(for standard fuel oil EL (sulphur content > 50 ppm),
neutralisation of the condensate is required).
Condensate lifting system with a zero-volt alarm output
comprising:
1 condensate lifting pump with a zero volt alarm output
1 condensate tank with cover and wall mounting bracket
1 PVC hose, 10 mm (6 m long)
1 non-return valve
1 condensate inlet adaptor