25 | Page
Slide the OTR switch down. The unit will vibrate 3 times and will begin recording audio and video.
To Deactivate Video Recording:
Slide the OTR switch up. The unit will vibrate once and stop
recording.
During Video Recording you can:
• Activate and Deactivate the flashlight by pressing the
flashlight button (14)
• Silently snap a photo by pressing the Snap Shot button
(2). The Vision allows the unit to snap photos while
simultaneously recording video.
• Confirm whether or not the unit is recording video by
checking the Status indicator light (13). Steady Red= Recording in Progress, Yellow=Unit is charging.
Green=Unit is fully charged.
How to Charge the unit:
Plug the supplied 10 pin USB cable into the bottom of the unit and the other
end into the USB port on your computer or to the wall. The status LED on
the top of the unit will turn "Yellow"(charge). Once the Status LED turn
"Green" it means that the unit is fully charged.
If your unit came with a docking station, insert the Wolfcom Vision into any
available port on the docking station. Make sure that the docking station is
powered on and that the docking station is plugged into the wall using the
included power supply.
IMPORTANT* The USB cables that are included with your unit are specially
designed with a 10 pin connection. Using a 3rd party USB cable will not work
and may damage the unit. Please be sure to only use the cables that came
with your unit.
How to extract files from the unit:
Click on the Wolfcom Vision Setup Manager icon on your computer desktop. You should see an Icon that looks
like this:
1. First make sure that the OTR Switch (1) is in the
up position and that the unit is powered off.
2. Next make sure that the Function Switch (6) is set
to the up position.
3. Plug the supplied 10 pin USB cable into the
bottom of the unit and the other end into the USB
port on your computer.
To Next Page
Loading...