Wolfcom Vision - Page 34

34 | Page
ON - Once recording is activated indicator will Stay ON Steady RED
22
Date & Time Stamp
Sets the Date and time Information stamp on each video and picture.
NO - There will be NO date and time stamp on the video or picture.
YES - There will be date and time stamped on the top left of the video and
picture
23
GPS Stamp
Sets the GPS coordinate Information stamp on each video and picture.
Only used If You are using the GPS Module Pack accessory.
OFF - There will be NO GPS coordinates stamp on the video or picture.
ON - There will be GPS coordinates stamped under the date and time
stamp on the top left of the video and picture
24
One Touch Record
A.V.D Technology
This section will allow you to configure the method of how you will power
On/start and off/stop recording on your unit. You can choose between
Normal and Advance with A.V.D technology.
Normal- To power on/start recording slide OTR switch DOWN. To power
off/stop recording slide OTR switch UP.
Advance A.V.D - To power on/start recording, slide OTR switch DOWN.
To power off/stop recording, slide OTR switch UP, DOWN, UP.
(Recommended)
25
Language
Language for Wolfcom Vision Set Up Software (English Only)
26
Current Settings
This section will automatically load your current Unit settings once a unit is
connected to a PC. *Current Setting will clear every time a unit is
connected or the software is exited.
27
Reset to Factory Default
Sets the unit back to Manufacturer default settings *If this feature is used
be sure to exit the Wolfcom Set up manager software. (How to exit
see below.)
NO - Will keep current saved settings
YES - Will reset and change all settings back to factory default
28
Format
Used to permanently erase all the memory on the unit. *If this feature is
used be sure to exit the Wolfcom Set up manager software. (How to
exit see below.)
NO - Will keep current files saved on the unit
YES - Will permanently erase all file and clear the memory.
29
Connect to Computer
Once a unit is connected. Click the button to view the files on the unit
30
Apply Settings
If any settings are changed you must click this button to save your new
settings.
How to "Exit" the Wolfcom Vision Set up Software:
On the bottom right of your screen, next to the time and date you will see an icon. Right click the
icon and click on exit.