Woodward DTSC-200A - Chapter 2. Navigation and Operation; Front Panel and Display Overview; LED Indicators

Manual 37941A DTSC-200A - ATS Controller - Operation
Page 6/37 © Woodward
Chapter 2.
Navigation / Operation
1
2
3
4
5
8
7
9
11
14
16 17 18 19
20 21 22 23 24
6
Figure 2-1: Front panel and display
Figure 2-1 illustrates the front panel/display, which includes push buttons, LEDs and the Liquid Crystal display
(LC display). A short description of the front panel is given below.
1
LED Alarm
Flashes if a new Alarm is triggered. Not acknowledged yet.
Shows that the device has minimal one unacknowledged alarm.
2
LED COMM OK
The LED flashes if any CAN message as RPDO is receipt.
3
LED ATS Inhibit
The LED indicates that the ATS transfer is inhibited.
12
LED S1 ok
The LED indicates that the source S1 is okay according to the configured operating ranges.
13
LED S1 breaker closed
The LED indicates that the load is connected to the S1 source.
14
LED S2 breaker closed
The LED indicates that the load is connected to the S2 source.